Light Weight Flywheel

For 1.6 Mazda 200mm clutch
Flywheel can be used with a 1.6 clutch and bolted to 1.8L Miata engine for improved response

• Made in USA
• 6061 T6 Aluminum
• 4340 billet steel friction ring
• 7.8 lbs - (stock 19 lbs)
• Chamfered ring gear for smooth starter engagement
• Exceeds SFI 1.1 Specification
• Pre -balanced, ready to install
• Does not require special fasteners, works with any brand 1.6 Miata clutch

Make your engine super fast revving. This is my favorite Miata modification because it wakes up the engine response so well. Makes heel toe rev-matched downshifting much easier. You may experience some increase in drive train noise at idle and on deceleration. Driveability is very good, no problem taking off from a dead stop.

NOTE: This flywheel will only bolt to a 200mm 1.6 clutch. 225mm 1.8 clutch will not fit this flywheel.